The INTACT YTX12-BS motorcycle battery, 12 volt, 10 Ah, is a sealed gel battery that delivers 30% more starting power. The INTACT YTX12-BS comes filled and charged and is extremely resistant to vibration. It can be installed at an angle of up to 90° and is designed specifically for modern motorcycles with many electrical consumers and ABS. Also suitable for modern scooters, snowmobiles and jet skis. Voltage (V): 12V. Capacity (Ah): 10Ah. CCA (A / EN): 210. Length (mm): 150. Width (mm): 87. Height (mm): 132. Overall height (mm): 132. Batteries bought from e-Moto.gr are under warranty provided they are fitted by an authorised workshop or at our shop. Alternatively you can follow the steps below, which are also set out in the PDF under the photo. Check the battery voltage: before fitting it must read at least 12.6 volt on a 12v battery. If the voltage is below 12.6 v, repeat the charging procedure. Fitting it to the motorcycle without proper charging will shorten its life considerably. CHARGING CHECK: check the charging voltage by putting a voltmeter or multimeter across the battery with the engine running at 5,000 rpm — half throttle and lights on. The readings should fall within the range given by the motorcycle manufacturer. The ideal reading is usually 14 volt +/- 0.20 v. Note: with all of the above done you can be certain every procedure the manufacturer recommends has been carried out correctly. Every battery bought from our shop is charged before collection completely FREE, ready to use.